Vacuum Chucks:  

Standard Fixed Level and Planarizing Vacuum Chucks for:

  • Single die and piece-parts
  • 2” wafer or substrate chuck
  • 3” wafer or substrate chuck
  • 4” wafer or substrate chuck
  • 6” wafer or substrate chuck
  • 8” wafer or substrate chuck

    • Custom Fixed Level and Planarizing Vacuum Chucks available upon request

Combination Fixed Level or Planarizing Vacuum Chucks:

  • 2” chuck for single-die, piece-parts and 2” wafers/substrates
  • 3” chuck for piece-parts, 2”, and 3” wafers/substrates
  • 4” chuck for 2”, 3”, and 4” wafers/substrates
  • 6” chuck for 4”, 5”, and 6” wafers/substrates
  • 8” chuck for 6” and 8” wafers/substrates

    • Combination vacuum chucks have multiple vacuum lines which can be individually selected and closed off as required

Backside Visible Vacuum Chucks:

  • (2) Spot Backside Visible (BSV) chucks for 2” up to 8” wafer/substrates BSV have (2) areas on wafer center-line that are approximately 0.75" to 1.0" diameter illuminated via adjustable intensity fiber optic illuminators and fiber pipes. Minimum 1.0” split-field separation in X-direction and +/-0.8” movement in Y-direction.
    • (2) Co-axial fiber optic illuminators
    • (2) XYZ micrometer stages
    • (2) fixed magnification tubes
    • (2) 2x adapters
    • (2) 1/4” CCD cameras
    • Image Grabbing System Hardware and Software with Image Overlay Function

    BSV alignment accuracy down to +/-1 μm

Backside Infrared Vacuum Chucks:

  • (2) Spot Backside Infrared (BSIR) chucks for 2” up to 8” wafer/substrates BSIR chucks have (2) areas on wafer center-line that are approximately 0.75" to 1.0" diameter illuminated via adjustable intensity fiber optic IR illuminators and Quartz fiber pipes. Chucks can also be purchased with (2), (4) or (6) illuminated spots. Requires use of Dual CCD cameras for IR imaging with infrared sensitivity from 0.8 to 1.2 μm

    BSIR alignment accuracy down to +/-2 to +/-3 μm

Custom Recessed Vacuum Chucks:

  • Standard vacuum chucks can be used for wafer/substrate thickness up to maximum 0.25” (6 mm). Thicker wafers/substrates can be accommodated with custom recessed vacuum chucks
Vacuum Mask Holders:  

Top-Load Vacuum Mask Holders Sizes (round or square opening):

2", 2.5" 3", 4", 5", 6", 7", & 9"

Bottom-Load Vacuum Mask Holders Sizes (round or square opening):

2", 2.5", 3", 4", 5", 6", & 7"

Top-load and Bottom-load Vacuum Mask Holders are available for any mask size and thickness including standard 0.060", 0.090", and 0.120" thickness

Custom mask holders are available upon request

All mask holders include pre-alignment/stop pins for precision and repeatable placement of photomasks on mask holders
  Back to HOME Page